Introduction
Skelestruder brings big improvements in ease of use. In addition to things like clear view of the nozzle while printing (so valuable), some more niceties listed below.
-
-
You can view the nozzle during the print which is great for troubleshooting and watching the first layer!
-
-
-
By turning PINDA adjust knob, it is simple to adjust PINDA height. For example when swapping between smooth and textured PEI sheet or different brand nozzles.
-
Turn knob counterclockwise (looking down at bed) to lower PINDA which increases nozzle clearance to bed.
-
Each detent click is 0.1mm height change. You can use this to easily bring down a high Live Z value. Example, 3 clicks clockwise subtracts 0.300 from Live Z.
-
My textured PEI sheet is about 0.2 thinner than the smooth. So when I swap, I simply adjust the PINDA and don't even change the Live Z or run first layer calibration. It just works.
-
-
-
Unhook tensioner by lifting knob up slightly while sliding out of idler. Then drop slightly to release spring tension and pull tensioner out completely.
-
Watch pinda cable when removing and installing tensioner
-
Now idler gate can be swung all the way up. This allows easy maintenance, clearing jams, or setting MMU load distances.
-
Advanced Use: between MMU loads, I sometimes open this up and clean out debris.
-
-
-
To adjust tension on idler, turn tensioner knob clockwise (looking down) to increase tension.
-
Turn 1/2 turns only and make sure pivots are set in idler detents. There are indicators on the top of the knob aligned with the pivots.
-
May need to hold screw head to keep it from turning.
-
-
-
To briefly disengage Bondtech gears for manual load / unload, just pull up from under idler edge (not the knob!) slightly until you can free filament.
-
You can brace your thumb on the filament cover.
-
Use this to catch/hold the filament while waiting for nozzle to heat before fully loading.
-
-
-
There is a sight line between the horizontal lever of idler and top edge of Ecage F.
-
When unloaded, the idler will be below this edge
-
When filament is successfully grabbed by gears, the idler will rise up above this edge. Useful for MMU2 debug.
-
-
-
To check if your Bondtech gears run aligned and see what effect they are having on your filament, unscrew the Cover/Cartridge during a print
-
Do not fully unscrew the front screw. It holds the Cover to the Cartridge and lets you pull out both together
-
Now you can watch the gears driving down the filament and adjust tension as needed
-
This is for advanced users and risk of damage if not careful. X-carriage will move on its own since still printing.
-