Pending Edits to 4. Assembly
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step #24 edited: [Step edited]
Edited by Tim Hoover (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Noctua | |
| - | [* 5] Use two M3x18 screws to mount the |
| - | [* 3] Use the already in the shroud |
| + | [* 5] Use two M3x18 screws to mount the left side of the Nocuta fan |
| + | [* 3] Use the M3x12 screws already through the fan and in the shroud to mount the right side |
| [* 10] Some have found M3x14 works better depending on print fit | |
| [* 8] Make sure everything is aligned and that there are no major gaps between shroud and the E-Cage | |
| [* 10] Tiny gaps wont have influence on cooling and can be ignored |
Step #13 edited: [Step edited]
Edited by Tim Hoover (1)
(You don’t have enough reputation to patrol this edit.)
| [title] E-Cage Check | |
| [* 1] Before proceeding, check your progress again and make sure all is aligned. This avoids taking things apart again during the assembly. | |
| [* 6] Insert M3x18 from the back into E-Cage F as motor anchor screw | |
| [* 10] You can defer this until step 19 if preferred. | |
| [* 8] The bearings of E-Cage B and E-Cage F are aligned | |
| [* 3] V6 is aligned correctly | |
| [* 10] You can angle heat block slightly to match Omega outlets if desired | |
| - | [* 5] No gaps between E-Cage B and E-Cage F. Inlet |
| + | [* 5] No gaps between E-Cage B and E-Cage F. Inlet should be secured without gaps. |