Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
11
no it’s definitely a screw length issue. I had to use a longer screw and that solved it.
The connector of the stepper motor does not fit into the header on the EINSY board. How did you fix this problem?
I too had to jerry rig it. Personally I ground down an M30 to 27mm to make it grip the nut.
I had to use an M3x20 screw instead of the M3x18 in picture 2. The M3x18 ends up being flush with the printed part, leaving nothing sticking out to screw into the motor.
How important are the nylon washers? I don’t have any on hand. Is it enough to 3d print a washer of similar width?